Duplicity Necklace – How To From Fernando’s Atelier

This is a wonderful project featuring purple and green, so favoured in so many of the trend reports for the Fall.  It is another necklace design created by Fernando for our series:  Fernando’s Atelier.

Fernando has created many pieces of jewelry which are displayed in the John Bead showroom.  Some of these designs appear in our catalogues and may have been published.  For those of you who can’t visit in person we will have a regular post on this blog giving you a closer look at the finished jewelry.  Fernando has written all the instructions and is sharing them with you. Welcome to the series we call: Fernando DaSilva’s Atelier. 

Instructions:

1.  Cut an 8 inches piece of stringing wire and string on a crimp tube followed by a wire guardian.  Pull one of the ends of wire close to crimp and crimp it properly. Trim short excess wire.

2. String beads as follows: one seed bead + one large bead cap +  one 12mm pearl + one bead cap + one seed bead + emerald cat eye cube + one seed bead. Repeat pattern until you have 8 seed beads strung on. Alternate cat eye cube colors using one of each of the other two.

3. Finish end in the same manner that was done in the beginning.

4. Create a second string shorter than the previous using same style of  beads – this will be the inside strand.

5. Feed one peacock bead, followed by one spacer bar (through one of the end holes) and then add a second peacock bead. Make simple loop at the opposite end and trim excess wire. Add a similar link to far end hole of spacer bar using same quantity of beads. Create a second section to be used on the other side of necklace. Set them aside.

6. Cut chain in 2 equal pieces of 7 inches. Set aside.

7.  Cut a second piece of chain in 2 equal pieces of 6 ½ inches. Set them aside.

8. Open 2 jump rings  and attach both to circle portion of toggle clasp, followed by one 7 inches piece of chain. Close both jump rings and then attach end link to one of the loops of the peacock-beaded link. Open opposite eye pin loop and attach to beaded section created on step 2.

9. Attach another 7 inches piece of chain to the opposite side of previous strand.

10. Attach short chain, beaded-peacock section and beaded link on same manner you attach the previous strand, adding other portion of toggle to finish necklace.

Here is a list of the materials he used for Duplicity:

2 emerald green cat eye cubes

2 apple green cat eye cubes

2 olive green cat eye cubes

8 peacock beads

4 multicolored 12mm pearls

4 multicolored 10mm pearls

4 gold plated wire guardians

16 galvanized green Miyuki seed beads

2 ½ inches of antique brass large/small heart link chain

6 round gold plated 7mm  jump rings

2 bronze spacer bar 5 holes

8 bronze bell cap flower

8 bronze cap

4 copper crimp tubes #2

Beadalon satin gold stringing wire

Tools:

 Side cutter,  Flat noseRound nose  Crimper Tool 

This entry was posted in Beadalon, Chain, Fernando DaSilva Atelier, Findings, Fire Polish Beads, Other Beads, Pliers and tagged . Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *